■)r -.'l /9i.4 MDDC - 964 \y UNITED STATES ATOMIC ENERGY COMMISSION OAK RIDGE TENNESSEE 184" CYCLOTRON Oscillator Capacitance Measurements by R. L, Anderson Published for use within the Atomic Energy Commission. Inquiries for additional copies and any questions regarding reproduction by recipients of this document may be referred to the Documents Distribution Subsection, Publication Section, Technical Information Branch, Atomic Energy Commission, P. O. Box E, Oak Ridge, Teimessee. Inasmuch as a declassified document may differ materially from the original classified document by reason of deletions necessary to accomplish declassification, this copy does not constitute authority for declassification of classified copies of a similar document which may bear the same title and authors. Date of Manuscript: March 18, 1947 Document Declassified: May 23, 1947 This document consists of 1 page. Digitized by the Internet Archive in 2011 with funding from University of Florida, George A. Smathers Libraries with support from LYRASIS and theSlaan Foundation http://www.archive.org/details/184cyclotronosci00usat - 1 - MDDC - 964 184" CYCLOTRON Oscillator Capacitance Measurements By R. L. Anderson Experiment done by R. L. Anderson and J. Riedel Introduction Capacity of the oscillator plate to ground was requested by Mr. Pote', electrical en- gineer at Harvard University. It was also desirable to have this information for comparison with model measurements and for the records. Experimental Setup: The oscillator housing was separated from the transmission line housing, and the oscillator plate coupling'loop was disconnected at its grounded end. The water lines run- ning through the loop were disconnected at their entrance into the loop. The G-R imped- ance bridge leads were connected to the 9C21 tube water jacket and to the oscillator housii^. For accuracy an oscilloscope was used in balancing the bridge. (Oscillator wiring diagram, Dwg.#2L2754) . Results: The plate to ground capacity with coupling loop disconnected was 113 jufii. The plate to ground capacity with coupling loop disconnected and two 50/i//f vacuum capacitors added as in normal rim condition was 219////f. The grid circuit contains 15 - 50 ^f vacuum capacitors in parallel (calculated) - 750 /U^f. The filament circuit contains 10 - 50jufif vacuum capacitors in parallel (calculated) - 500 fifii. It was not deemed necessary to meas- ure the grid or filament circuits. The measurements were made with G-R Impedance Bridge, T3rpe 650-A Serial #1977, and are + 2/M//f. Lead capacity of 29 f/fit has already been deducted. UNIVERSITY OF FLORIDA iiiiiiiiiiiiiiii 3 1262 08909 7249 JH